For those that involving themselves in the RC servo motor industry, you must be fascinated with this oServo Object.

The oServo Object is a hardware object and it uses one digital I/O line to set the position of an RC servomotor. If you judge its ability through its appearance, then you must change your perception on this oServo Object.

oservo-object

For your information, the oServo Object is able to positioning an RC Servo within its 180 degree rotational span. Normally, the position within the 180 degree span is specified by a value with a range of 0 to 63. Once the servo has reached the specified position, it will hold in place until the specified position changes or the oServo Object is turned off automatically!

The oServo Object is very incredible because it can control the servo in low torque mode or high torque mode. It estimates that up to 20 servos can be controlled in either mode, as long as the modes are not all at full swing. In addition, up to 20 servos positioned at full swing can be controlled at low torque, while up to 6 servos positioned at full swing can be controlled at high torque!